Natural Gas Dehydration
Natural gas dehydration is the process of removing water vapor from natural gas. A gas dehydration system is used by oil and gas producers to dehydrate natural gas into a state where it can be sold downstream.
BTEX Condenser Unit
BTEX Condenser Units are essential components of natural gas dehydration processes. These units are designed to capture and condense harmful volatile organic compounds
Steam Heat Exchanger – Indirect Heater
Steam Heat Exchanger - Indirect Heater is used to heat the well effluent after it flows out of the well and prior to the separating process. This type of heat exchanger is also called a direct heating furnace which allows it to heat up the process coil directly. This is a kind of heating furnace that has the maximum heat exchange efficiency among the heating furnaces.
Steam Heat Exchanger
Steam Heat Exchanger
Steam-heat exchangers are used to raise the temperature of well effluents to prevent hydrate formation, reduce viscosity, and break down emulsions for efficient separation of oil and water. Because steam-heat exchangers drastically reduce risk, they are used on offshore platforms and in other work conditions where safety regulations do not permit the use of indirect-fired heaters.
Heat Exchanger
Heat exchangers are used to transfer heat from one medium to another. These media may be a gas, liquid, or a combination of both. The media may be separated by a solid wall to prevent mixing or may be in direct contact.
Horizontal Separators
Horizontal Separators
Horizontal separators are ideally suited to wellstreams having high gas-oil ratios, constant flow, and small liquid surge characteristics. Horizontal separators are smaller and less expensive than vertical separators for a given gas capacity. Liquid particles in the wellstream travel horizontally and downward at the same time as a result of two forces acting upon them-the horizontal force of the gas stream and the downward force of gravity.
Gas Scrubber
Stringent regulations on air pollution are being implemented globally, urging companies to adopt necessary measures. Gas scrubbers are legally mandated in industries where employees are exposed to potentially contaminated gases, making them a widely employed method for pollution control.
Separator Demister Pad
A demister is also known as a demister pad, mist pad, wire mesh demister, mesh mist eliminator, catching mist, and mist eliminator. It is a device often fitted to vapor–liquid separator vessels to enhance the removal of liquid droplets entrained in a vapor stream.
Coalescing Gas Separator
Coalescing gas separators are designed specifically for the removal of mist, fog, and dust from gas streams. These contaminants usually exist with the bulk of the particles having diameters considerably less than 10 microns; therefore, standard separators or scrubbers are not capable of effectively removing these minute particles.
Five basic methods for dehydrating or drying Natural Gas
Glycol dehydrators, also known as gas dehydrators or TEG units, are used to remove water vapor from natural gas. The process of dehydration is important for two reasons.